Instead of the network RAID 1 device formed by DRBD, we can also place our VMs into a Gluster filesystem.
As we have stated before, we will install three VMs with the CentOS platform for demonstration, based on the following network configuration:
Hostname |
VM node |
IP address |
Subnet mask |
Interface |
---|---|---|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
For our practice, we set up three physical servers connected to the same network in which the Proxmox is located; we assign the vmbr0
interface (to know how to configure it, please refer to the network preparation section of this chapter) for them to use. I assume that you have already set up the hostname, IP configuration, and the /etc/hosts
file.
After the network has been configured, we...