In this recipe, we'll run some tests to see how well Slic3r works with cooling procedures.
You'll need Slic3r and ABS and PLA filament. You'll also need the same calibration models that you downloaded in the previous recipe.
We'll start by running a few tests with the cube step calibration model and proceed as follows:
Slice and print the 5mm Calibration Cube Steps using the default settings.
In Slic3r, go to Filament under Filament Settings and change the Extrusion multiplier from the default value
1to0.8. Slice and print the model in PLA.In Slic3r, go to Cooling under Filament Settings and change the Slowdown if layer print is below from the default value of
30to5.0. Slice and print the model in PLA.Now we'll slice a quick test using the small pyramid. Slice and print the calibration pyramid in PLA with the current settings.
Repeat the previous steps using ABS, except change the default value
1in Disable fan for the first to100...