Book Image

Mastering Embedded Linux Programming

By : Chris Simmonds
Book Image

Mastering Embedded Linux Programming

By: Chris Simmonds

Overview of this book

Mastering Embedded Linux Programming takes you through the product cycle and gives you an in-depth description of the components and options that are available at each stage. You will begin by learning about toolchains, bootloaders, the Linux kernel, and how to configure a root filesystem to create a basic working device. You will then learn how to use the two most commonly used build systems, Buildroot and Yocto, to speed up and simplify the development process. Building on this solid base, the next section considers how to make best use of raw NAND/NOR flash memory and managed flash eMMC chips, including mechanisms for increasing the lifetime of the devices and to perform reliable in-field updates. Next, you need to consider what techniques are best suited to writing applications for your device. We will then see how functions are split between processes and the usage of POSIX threads, which have a big impact on the responsiveness and performance of the final device The closing sections look at the techniques available to developers for profiling and tracing applications and kernel code using perf and ftrace.
Table of Contents (22 chapters)
Mastering Embedded Linux Programming
Credits
Foreword
About the Author
About the Reviewers
www.PacktPub.com
Preface
Index

Network devices


Network devices are not accessed through device nodes and they do not have major and minor numbers. Instead, a network device is allocated a name by the kernel, based on a string and an instance number. Here is an example of the way a network driver registers an interface:

my_netdev = alloc_netdev(0, "net%d", NET_NAME_UNKNOWN, netdev_setup);
ret = register_netdev(my_netdev);

This creates a network device named net0 the first time it is called, net1 the second, and so on. More common names are lo, eth0, and wlan0.

Note that this is the name it starts off with; device managers, such as udev, may change to something different later on.

Usually, the network interface name is only used when configuring the network using utilities such as ip and ifconfig to establish a network address and route. Thereafter, you interact with the network driver indirectly by opening sockets, and let the network layer decide how to route them to the right interface.

However, it is possible to access network...