Let's first see what wireless networks our adapter is currently detecting. Issue the command iwlist wlan0 scanning and you will find a list of networks in your vicinity:

Keep scrolling down and you should find the Wireless Lab network in this list. In my setup, it is detected as Cell 05; it may be different in yours. The ESSID field contains the network name.

As multiple access points can have the same SSID, verify that the MAC address mentioned in the preceding Address field matches your access point's MAC. A fast and easy way to get the MAC address is underneath the access point or using web-based GUI settings.

Now, issue the iwconfig wlan0 essid "Wireless Lab" command and then iwconfig wlan0 to check the status. If you have successfully connected to the access point, you should see the MAC address of the access point in the Access Point: field in the output of iwconfig.

We know that the access point has a management interface IP address 192.168.0.1 from its manual. Alternately, this is the same as the default router IP address when we run the route –n command. Let's set our IP address in the same subnet by issuing the ifconfig wlan0 192.168.0.2 netmask 255.255.255.0 up command. Verify the command succeeded by typing ifconfig wlan0 and checking the output.

Now let's ping the access point by issuing the ping 192.168.0.1 command. If the network connection has been set up properly, then you should see the responses from the access point. You can additionally issue an arp –a command to verify that the response is coming from the access point. You should see that the MAC address of the IP 192.168.0.1 is the access point's MAC address we noted earlier. It is important to note that some of the more recent access points might have responses to Internet Control Message Protocol (ICMP) echo request packets disabled. This is typically done to make the access point secure out-of-the-box with only minimal configuration settings available. In such a case, you can try to launch a browser and access the web interface to verify that the connection is up-and-running:

On the access point, we can verify connectivity by looking at the connection logs. As you can see in the following log, the MAC address of the wireless card 4C:0F:6E:70:BD:CB has been logged making DHCP requests from the router: